INSTRUCTIONS:
- Print out the front and the back of the Pattern.
- Sandwich card stock between the front and back, glue. NOTE: be sure the tops and bottoms are facing the right way.
- Following outside edges, cut all three layers of pattern.
- Using the photograph for reference, carefully cut and glue trims to the ornament as follows:
- Starting at left side on holly branch, position and glue silver soutache braid along bottom of bird and over holly leaves to right side (see photo).
- Make an applied bow using the red ribbon and glue on branch over holly leaves.
- Glue points of blue jumbo rick rack around border, being careful not to cover the bird's head. Start and end at top, just under the hanger position.
- Insert narrow gold cord through hole and tie a knot creating the hanger.
- ENJOY!
NOTE: Use as much or as little of the trim; it's up to you. Remember, the more trimmed details, the more 3-D the figure will appear to be! |