1. Cut zipper 1" longer than desired finished length, leaving 1/2" at each end for seam allowances during application.
2. Line up bottom of slider to zipper teeth. Attach slider to hold (see Illustration 1).
3. Pulling gently on tape on each side of slider, separate teeth inside slider.
   HINT: Cut ends of tape into points to start feeding easier (see illustration 1). Also, if starting at one end is difficult, try starting at the other end.
   When slider is secured on teeth, pull slider downward (see Illustration 2).
4. Attach slider stop 1/2" from other end of tape. Push prongs of stop through tape, covering teeth with stop. Using pliers, squeeze prongs flat on backside of zipper (see Illustration 3).

Use with Wrights^® 183-9036-046 zipper slides and stops.